Know what, Rufus? I think this is the second time in just a couple of days that you've mentioned post and beam construction or squaring a log. I've always been a fan of Timberframing, and I've dabbled in it myself. But, I cheat like hell!

I use the radial arm saw with a dado blade to cut tenons, and I made up wooden jigs and use a router to cut the shoulder where another beam or a brace will penetrate a vertical beam. In other words, if the beam is roughly 6" square, and I want a 3/4" shoulder, I machine out the wood with all measurements made from the opposite side. And that basically is what the old timers did. A beam could be 8 1/2" on one end, but only 7/3/4" on the other end, and not square at all, so you use one end or side, and all measurements are taken from that side. A beam placed longways on 3 bents would be mortised and the upright of the bent would have the tenon, so if you were going to set rafters into the beam, (let's say a 12 x 12 pitch, (45 degree angle)) here's another place where I cheat. I made plywood jigs cut at a 45 degree angle, rout out a hole in them where the router bit can protrude through, then I anchor it to the top post and keep going around inside the hole with a plunge router and 5/8" x 2 1/2" straight cut bit. It puts a perfect step into the beam for the tail of the rafter, then another jig is positioned directly over the same place, and I cut in a step for the rafter to sit on. (we're talkin' a 4" x 6" x ? rafter). Then the holes would be drilled for the pegs, up to 1/4" offset, so that when the peg is driven in, it's pullin' the rafter hard and tight into the offsets. You only need one peg, or a single 30 penny spike, and that baby's never comin' out of there. Later this year, when I get the basement cleaned up of all my kid's junk, I'll take some pics of some of my crafting and show ya. But I can tell you this. Post and beam construction is really slow work in a one man operation.
If you agree with the Progressives, it's freedom of speech. If you disagree, it's hate speech. There are no alternatives.