Page 1 of 4
.
Posted: Wed Apr 11, 2018 5:35 pm
by 2railjon
.
Re: The 4-6-2 Pacific That Never Was!
Posted: Wed Apr 11, 2018 5:59 pm
by Robert
Looks like a beauty Jon...whatever you do don't reletter it Pennsy...
Robert
Re: The 4-6-2 Pacific That Never Was!
Posted: Wed Apr 11, 2018 6:10 pm
by 2railjon
.
Re: The 4-6-2 Pacific That Never Was!
Posted: Wed Apr 11, 2018 7:29 pm
by ScaleCraft
http://hawkinsrails.net/mainlines/nw/nw578.jpgChange the handrails, fix the forward running boards, spoke the lead truck wheels, change the sand dome, move the bell....make a reasonable representation.
Re: The 4-6-2 Pacific That Never Was!
Posted: Wed Apr 11, 2018 7:46 pm
by 2railjon
.
Re: The 4-6-2 Pacific That Never Was!
Posted: Wed Apr 11, 2018 7:51 pm
by Rufus T. Firefly
PSC used to sell spoked wheelsets, but I don't know if they are still available.
Re: The 4-6-2 Pacific That Never Was!
Posted: Wed Apr 11, 2018 7:54 pm
by ScaleCraft
Re: The 4-6-2 Pacific That Never Was!
Posted: Wed Apr 11, 2018 8:22 pm
by 2railjon
.
Re: The 4-6-2 Pacific That Never Was!
Posted: Wed Apr 11, 2018 8:57 pm
by 2railjon
.
Re: The 4-6-2 Pacific That Never Was!
Posted: Wed Apr 11, 2018 9:00 pm
by sarge
Wheels from the UK?
That would be Slaters.
Order direct from Tower Models in Blackpool. Tell 'em I sent you.
A 30" (2' 6")wheel in 7mm is close enough to 33" for your purpose.
Re: The 4-6-2 Pacific That Never Was!
Posted: Wed Apr 11, 2018 9:16 pm
by De Bruin
That slated pilot (no accident) looks like it as lifted off a generic PRR locomotive, perhaps you can find a similarly configured replacement part.
Re: The 4-6-2 Pacific That Never Was!
Posted: Wed Apr 11, 2018 9:52 pm
by 2railjon
.
Re: The 4-6-2 Pacific That Never Was!
Posted: Wed Apr 11, 2018 9:54 pm
by 2railjon
.
Re: The 4-6-2 Pacific That Never Was!
Posted: Wed Apr 11, 2018 10:51 pm
by Tom Dempsey
Also tell the Trainmaster to stop using passenger power to pull coal drags!
Re: The 4-6-2 Pacific That Never Was!
Posted: Wed Apr 11, 2018 11:15 pm
by De Bruin
Yeah, if you weren't up for cutting out the vertical tubes on that Precision pilot, I'd take a Kemtron #40 PRR Standard and narrow the ends and fix/soldier ends plates down to the foot steps.
Not an exact match mind you as the N&W has 5 tubes whereas the PRR has 5 slats and has those extra vertical braces on either side of the center
but you're in for some surgery either way.
I like these 4-6-2's, wish they made more of them, they run well.