Page 1 of 1
My Northern Pacific Z5 Project
Posted: Fri Jul 20, 2018 10:52 am
by 2railjon
From EBay for 975. Seller claimed C7-C8 condition. LOL.
All lights burned out and would not run without flywheel being pushed. So...

Rear marker lights and backup light replaced.

Front marker lights replaced.

Waiting on new Pittman motor to arrive from Scott.

Re: My Northern Pacific Z5 Project
Posted: Fri Jul 20, 2018 11:25 am
by bob turner
By now you know thar this model was one of Scott's true masterpieces? One wonders if the previous owner tried to run it with a Lionel transformer? A grand seems ok for this model, even with electrical flaws.
Re: My Northern Pacific Z5 Project
Posted: Fri Jul 20, 2018 12:10 pm
by 2railjon
Bob, I’m not sure what happened to it. I’ve always thought Pittman motors were pretty bulletproof! Bad commutator or pole? Luckily Scott had one in inventory! I scoured the internet with no success.

Re: My Northern Pacific Z5 Project
Posted: Fri Jul 20, 2018 12:46 pm
by cole7015
Yes 1K is a very good price. That is the same motor NWSL calls 40 60 MM best motor made for them back
in the R Martin era. I also say the previous owner fracked it up.
Bill
Re: My Northern Pacific Z5 Project
Posted: Fri Jul 20, 2018 2:38 pm
by 2railjon
Bill, you’re correct! The NWSL motor 40611-9 matches the dimensions my Pittman.

Re: My Northern Pacific Z5 Project
Posted: Fri Jul 20, 2018 6:18 pm
by cole7015
Raol Martine NWSL had Pittman build his motor to specific specifications and bought 500 +
motors they were double shaft and metal solder tabs, and I think 6K or 8700 rpm.
I bought the last 10 from NWSL Montana about a year ago. I have 2 installed in a Baldwin
centipede pulls 22 passenger cars average weight 3 pounds per car.
Bill
Re: My Northern Pacific Z5 Project
Posted: Fri Jul 20, 2018 7:41 pm
by bob turner
There was a time when you could buy them direct from Charlie Pittman for under $30, They had to be stock - I believe the 9433 is a stock motor.
Re: My Northern Pacific Z5 Project
Posted: Fri Jul 20, 2018 9:05 pm
by 2railjon
Scott finally got my motor out the door to me today!!
Re: My Northern Pacific Z5 Project
Posted: Thu Jul 26, 2018 9:38 pm
by 2railjon
The NP Z5 and Erie L1 finally hit the rails!!!!
https://youtu.be/xKHH3-IOihM
Re: My Northern Pacific Z5 Project
Posted: Fri Jul 27, 2018 8:59 am
by rogruth
Nice stuff, Jon.