Trestle Bents
Posted: Sun Feb 09, 2020 12:03 am
25 years ago, I was given a big box of wooden bents, all sizes, and a double-tracked scratch girder bridge.
I dragged them out of the basement to see what I could do with them thinking using them on the mountain branch line.
These.
Are.
Bad.
Wood dowel, two sizes, center runs aren't even vertical, then I looked at them closer.
White glue construction. A LOT of white glue. As in, it would take me HOURS to trim the huge globs and drips off. About 10 headers were loose, filed of the glue and re-glued.
About 2/3 of them are single track width, rest are 1-1/2 track width, couple double track.
Sprayed with flat black paint over all of it, glue globs and runs and all.
I am thinking they go in the trash.
Not even good enough for a HiRail line.
There was a well known (among the community) railroad in North Seattle/Richmond Beach area...came from there. Ripped out before I came along.
Builder was a civil engineer, worked for NP, I think it was.
I worked on a roundhouse he built that ended up at Garberson's. Pile of kindling. Took months to fit all the pieces in the correct places, glue and straight pin until set. Not ONE stall had the same dimensions as the others, and it was 12-15 stalls. Like doing a thousand piece jigsaw puzzle without a picture.
I hate to see stuff like this......probably a good ten-foot railroad when it was in service.
Rant mode "off".
I dragged them out of the basement to see what I could do with them thinking using them on the mountain branch line.
These.
Are.
Bad.
Wood dowel, two sizes, center runs aren't even vertical, then I looked at them closer.
White glue construction. A LOT of white glue. As in, it would take me HOURS to trim the huge globs and drips off. About 10 headers were loose, filed of the glue and re-glued.
About 2/3 of them are single track width, rest are 1-1/2 track width, couple double track.
Sprayed with flat black paint over all of it, glue globs and runs and all.
I am thinking they go in the trash.
Not even good enough for a HiRail line.
There was a well known (among the community) railroad in North Seattle/Richmond Beach area...came from there. Ripped out before I came along.
Builder was a civil engineer, worked for NP, I think it was.
I worked on a roundhouse he built that ended up at Garberson's. Pile of kindling. Took months to fit all the pieces in the correct places, glue and straight pin until set. Not ONE stall had the same dimensions as the others, and it was 12-15 stalls. Like doing a thousand piece jigsaw puzzle without a picture.
I hate to see stuff like this......probably a good ten-foot railroad when it was in service.
Rant mode "off".
