ScaleCraft wrote:For a 3D printed shell only.
Mister Firefly....you do some traction stuff....what gives? Special run? Highly sought after?
Cost of 3D printing is in the run time; full body shell takes time to do - no idea what this really costs - probably through Shapeways but there's another trolley 3D printer out there doing bodies shells and some other stuff- don't recall his name.
~5-6 years ago the first full body trolley shells were on tables at meets - $300-400.
By the time you finished the model completely at that point in time you were looking at an $800 investment to get a car that was otherwise unavailable unless you scratchbuilt it yourself. 3D printing caters to the guy that can't/won't scratchbuild traditionally.
Brass body shell -- old Kidder import -- might cost roughly the same were it available.
Wish that these guys would just print the sides and ends separately, cut the costs, use a wood or resin roof; could just print masters and resin cast replicates..........