Page 1 of 1

Thomas Industries 0-4-0

Posted: Fri Jun 04, 2021 8:58 pm
by ScaleCraft
In your junk bins, anybody have a spare main rod?
Or main rod attached to crosshead/piston rod?

I just got this one running (howinthehell Woody managed to get the front siderod holes triangle shaped I have no idea), but it's missing the main rod. Crankpin screw is there, crosshead is there (but badly worn, unlike opposing crosshead which is fine).

1-7/8 c/l to c/l. I can scrounge a chunk of brass and make one, but like to find the original pot metal one.

TNX

Re: Thomas Industries 0-4-0

Posted: Fri Jun 04, 2021 9:24 pm
by bob turner
Photo, please. I have some small pot metal main rods that may work. Need dimension from wrist pin to crank pin.

Re: Thomas Industries 0-4-0

Posted: Fri Jun 04, 2021 9:51 pm
by ScaleCraft
I'll mail you a photo. 1-7/8" wrist to crank (c/l to c/l).
Bent funny like a Half Zero Varney to clear rods and line up crosshead.
I've got a spare A-N main somewhere, no idea of spacing or if it will even look right.

Re: Thomas Industries 0-4-0

Posted: Fri Jun 04, 2021 11:00 pm
by ScaleCraft
Photos in your inbox in one e-mail, Challenger chassis tied down for shipment in another e-mail.