Page 1 of 1
Lobaugh CHallenger parts
Posted: Sat Sep 30, 2023 8:53 pm
by Dennis Holler
Re: Lobaugh CHallenger parts
Posted: Sat Sep 30, 2023 10:08 pm
by bob turner
You are lucky I forgot to bid.
First, you have a genuine rear cylinder block and a genuine unmachined rear frame. Let me study your photos a bit.
Yes. Two “unmachined” rear frames. Front frame is not Lobaugh, but looks ok. Front cylinders look like Lobaugh from here.
Bob Stevenson has rods that fit - both early and late Challengers. Keep your eyes open for 66” Boxpok driver sets.
Motor and gears are the easy part. Happy to help when you get that far. I will post a photo or two soon.
Re: Lobaugh CHallenger parts
Posted: Sat Sep 30, 2023 10:27 pm
by Dennis Holler
I got these a while back, I know they are not Lobaugh but they are about the right size...

Re: Lobaugh CHallenger parts
Posted: Sun Oct 01, 2023 2:02 am
by bob turner
They will keep you busy. If not Lobaugh, they may need to be annealed. You will know immediately if they are hard to cut.
Re: Lobaugh CHallenger parts
Posted: Sun Oct 01, 2023 10:12 pm
by steamaheadstephen59
Ye not as much challenger bits and pieces around as there was! Im still collecting. Scratch built the boiler out of copper aircon pipe, frames and drivers from "Locomotive Work Shop" from when they had Lobaugh parts. still got a ways to go.
Re: Lobaugh CHallenger parts
Posted: Sun Oct 01, 2023 10:52 pm
by Dennis Holler
I know what you mean, I do the same thing, picking up stuff when I see it if the price is good then waiting for more parts to turn up lol. I feel like I buy all the lots of driver castings I see listed. I really need to make it to a good O scale show and find some more parts though lol
Re: Lobaugh CHallenger parts
Posted: Sun Oct 01, 2023 10:52 pm
by Dennis Holler
sorry I double posted lol...
Re: Lobaugh CHallenger parts
Posted: Thu Oct 05, 2023 8:03 pm
by steamaheadstephen59
It’s really the hard way to do it thou. I prefer to get a whole or compleat model that needs a little work. The postage on small parts or collection of parts, can be as much as a whole loco. There are some parts on eBay I need worth I’d say $20 or $30 Australian but the postage Is $150 Australian. I purchased a Scale Craft loco and It cost $55 Australian to post, how does that work?? The accumulation of parts gets to become more than whole loco.
Re: Lobaugh CHallenger parts
Posted: Thu Oct 05, 2023 9:27 pm
by Dennis Holler
Stephen,I can appreciate that!! I found your old posts and now see what a real front frame looks like. Mine looks like a 4-6-2 frame now. You did a good job on your boiler!