Scratch Building in Brass
Posted: Thu Sep 26, 2024 2:00 pm
I note Retroniac's thread on building in brass:
https://ogrforum.com/topic/building-a-b ... locomotive
I am long since persona non grata on that forum, so cannot opine there - but I can do so here.
It looks like, having only viewed the first four minutes of the video, that the craftsman there is assembling a kit - and that the kit is of a Japanese Railway Hudson type (I am sure they do not call 4-6-4s "Hudsons" in Japan).
As I understand it, there were two versions of this kit - one was kind of cheaply done, the other was done with really good castings and sheet metal components. Not at all sure of this, but I believe the cheaper version was the IMP, or International, import to the US. The video seems centered on high quality components.
Really scratchbuilding a model steam locomotive in brass involves taking raw brass, and machining, rolling, forming, and soldering/fastening it into a form resembling a locomotive. It often allows for commercial castings - for instance, I would never even attempt a scratchbuilt O Scale Westinghouse cross-compound air pump. They are too easy to purchase, often for very few $. I have occasionally machined my own drivers, and while I have never personally cast anything, I have many times made masters and had castings made from them at a foundry.
I so far have not tried to load anything into Youtube, but if I were going to do so, I would show my technique for turning bar rail into boilers, and plate brass into frame sides.
https://ogrforum.com/topic/building-a-b ... locomotive
I am long since persona non grata on that forum, so cannot opine there - but I can do so here.
It looks like, having only viewed the first four minutes of the video, that the craftsman there is assembling a kit - and that the kit is of a Japanese Railway Hudson type (I am sure they do not call 4-6-4s "Hudsons" in Japan).
As I understand it, there were two versions of this kit - one was kind of cheaply done, the other was done with really good castings and sheet metal components. Not at all sure of this, but I believe the cheaper version was the IMP, or International, import to the US. The video seems centered on high quality components.
Really scratchbuilding a model steam locomotive in brass involves taking raw brass, and machining, rolling, forming, and soldering/fastening it into a form resembling a locomotive. It often allows for commercial castings - for instance, I would never even attempt a scratchbuilt O Scale Westinghouse cross-compound air pump. They are too easy to purchase, often for very few $. I have occasionally machined my own drivers, and while I have never personally cast anything, I have many times made masters and had castings made from them at a foundry.
I so far have not tried to load anything into Youtube, but if I were going to do so, I would show my technique for turning bar rail into boilers, and plate brass into frame sides.