2 pages or so back I posted pictures of this CPR conductor's van car that I snagged off eBay. Obviously needed a lot of work but it had a certain attractiveness that I let sway my judgement towards its acquisition; why a CPR can would be on the CVRR will be an unresolved mystery....
In any case, started in on it and removed the roof - nearly fell off actually, and the doors fell out and then the fun began... Car body is 1/32" scribed siding, windows are built up from paper with the moutons on the inside of the glazing- very fragile, lintels over the door openings fell out, etc.
End railings are a nice and the wire is salvageable, but the end sills are both broken with parts missing, and the wood is "brittle". Remains of the steps appear to have been made from the old Walthers green plastic seats cut up into steps. Barely have enough to capture one step, so those are getting replaced. Underside is spartan and it appears that someone literally ripped the couplers off leaving a good sized gouge at each end. Wood filler time....

A little reinforcement, and replacing those door bits - the more I work on this car, the more surprising it is to me that it survived shipping and did not arrive as a bundle of sticks.
Doors are interesting...

Door runners at the top are something new to me - very thin steel at first glance and then after a closer look, you might be able to see the sharp edge - razor blades! One was loose - Goo and CA to re-attach. CA just soaks into the wood on this car like a sponge.
So, while it's apart and getting re-assembled, I'll build a 2nd one in parallel........maybe just slightly more robust in wood that will also allow for a somewhat less spartan underbody.