I tried to slightly bend/flatten it when my King Kongness started showing...SNAPPED right in half
I swear I didn't put hardly any pressure on it, but it was enough. Now I've got it sitting while the JB Weld dries to see if that will keep things together. There was a small cavity on each side where the diecast fuel tank fits so I filled it up with JB and screwed the fuel tank in place.
Hopefully between the JB and the fuel tank scrws (and the fact the fuel tank is now JB Welded in place) that will fix my "mistake"
I was thinking about drilling and tapping some flat brass until I saw the tank fit into those 2 cavities.
Lesson learned...leave diecast alone. Now I have to wait a day and still have to figure out where to put the on/off switch and charging jack, the 9.6v, 2000Mah, NiMh battery pack fits nice between the 2 vertical motors, but I might have to make the engine shell so that in pops off vice having 4 screws coming from the bottom.
What a dunce, I should have known better.
I would post a photo but I've already put it together so the JB can dry.
