Things NOT To Do With Die-Cast!!!

Discuss All Facets of 2-Rail, 1/48 Scale, Model Railroading
Seaboard Air Line Fan
Posts: 1308
Joined: Mon Mar 08, 2004 9:49 pm
Location: Virginia

Re: Things NOT To Do With Die-Cast!!!

Postby Seaboard Air Line Fan » Wed Feb 14, 2018 5:20 pm

Lots of good ideas folks, thanks!

I used Gorilla Gel Super Glue to reattach the broken (or Borken as they say on OGR :lol: ) piece, then put my draftsman skills to work and drew a pattern for a Stiffening Plate, take a look:

DSCN0132_870.JPG
DSCN0132_870.JPG (249.45 KiB) Viewed 2149 times


DSCN0133_871.JPG
DSCN0133_871.JPG (241.09 KiB) Viewed 2149 times


DSCN0134_872.JPG
DSCN0134_872.JPG (246.84 KiB) Viewed 2149 times


NW2 stiffening plate.jpg
NW2 stiffening plate.jpg (581.35 KiB) Viewed 2149 times


If I use .060" brass sheet it should work fine, maybe even down to .030". JB Weld it to the truck and see what happens.
BobD aka Drifty

The Crow Flies At Midnight

Seaboard Air Line Fan
Posts: 1308
Joined: Mon Mar 08, 2004 9:49 pm
Location: Virginia

Re: Things NOT To Do With Die-Cast!!!

Postby Seaboard Air Line Fan » Wed Feb 14, 2018 5:33 pm

When Atlas came out with their GP9 I bought an unpowered unit. Didn't take long to figure out I didn't need it so I called them and bought the drive gear assembly. Still didn't have any motors until I saw a RailKing F3 on Ebay for real cheap. Took the motors and mounts off that and THEY FIT the Atlas GP9 :shock: been running fine ever since.

I'll check around for some trucks, thanks!
BobD aka Drifty

The Crow Flies At Midnight


Return to “O-Gauge, 2-Rail, Model Railroading”

Who is online

Users browsing this forum: No registered users and 50 guests