chuck wrote:Thanks. I had some of that but stopped using it when I ran across Tenax 7R (which turned out to be 100% methylene chloride).
Which unfortunately is not available in that form now......and I hope my stock lasts a while.
I have the Testors MSDS and the ingredients are Xylene, N Butyl Acetate, Ethyl Benzene, Toluene, Naptha, and Polystyrene.
Hilarious - panic over and ban methylene chloride yet Xylene, Ethyl Benzene, and Toluene are acceptable. N-Butyl acetate is interesting - used to use it to test ventilation system quality -- smells a lot like bananas
The "no tox" blue label is basically citrus oil and usually makes quite a mess. I have left many fingerprints in styrene while trying to use it. I almost never seems to set completely. I suspect that's because it is "oil" based.
I'll have to see if I still have a bottle of the black stuff that hasn't dried up and run some tests on it. It would be nice to have something that is a little less aggressive than methylene chloride. Tamiya extra thin (green label) is 50/50 mixture of Acetone (methyl methyl keytone) and Butyl Acetate.
A little less aggressive than methylene chloride would be nice, yet something that actually worked cleanly would also be good. Acetone literally blows away....N-Butyl acetate boils at over 100 degrees C so it's not going away.
Hate to suggest MEK; terribly flammable, nasty smelling, and all sorts of respiratory tox, but it does work on lots of plastics.....and it's still available as far as I know.


