Carey Williams wrote:Hello all
Icken offered a GG1 in the late 1930's, catalog illustration shows four motors ...the 2 survivors ( that I know of ...no doubt a few more are out there) ..only have 2 motors .
Cheers Carey
Probably a reason 4 motor units did not survive.
I have experience with a 4-motor engine. GP-20, I think it was. Plastic. Fairly light weight.
There is always the possibility of worm lock when more than one motor is propelling a device.
I cannot imagine how bad that COULD have been with all that weight, where wheel slip to compensate for motor speed variations was less available.
We series-wired motors to try to get them more in line with matching speeds.
As they got older, I can't imagine how they would fare with gear wear, bearing wear, brush wear, armature windings with possible failing insulation.
We run engines here with double motors, single lead worms, on two trucks (Shay) that no matter what you do lurch at low speeds with worm lock. All our rod engines have been upgraded with new gearboxes using double lead and ball bearings, and double heading can be...interesting on downgrades.
I suppose flat and level track would be less of an issue, but on a downgrade?
I'd like to see one of the non-existent 4-motor GG1's someday and run it. Garberson has a good downgrade from upper level to lower.