Icken GG1 vintage O scale

Discuss All Facets of 2-Rail, 1/48 Scale, Model Railroading
User avatar
ScaleCraft
Posts: 6693
Joined: Thu Jan 26, 2012 10:15 pm

Re: Icken GG1 vintage O scale

Postby ScaleCraft » Tue Aug 30, 2022 3:04 pm

Carey Williams wrote:Hello all

Icken offered a GG1 in the late 1930's, catalog illustration shows four motors ...the 2 survivors ( that I know of ...no doubt a few more are out there) ..only have 2 motors .

Cheers Carey


Probably a reason 4 motor units did not survive.
I have experience with a 4-motor engine. GP-20, I think it was. Plastic. Fairly light weight.
There is always the possibility of worm lock when more than one motor is propelling a device.
I cannot imagine how bad that COULD have been with all that weight, where wheel slip to compensate for motor speed variations was less available.
We series-wired motors to try to get them more in line with matching speeds.
As they got older, I can't imagine how they would fare with gear wear, bearing wear, brush wear, armature windings with possible failing insulation.

We run engines here with double motors, single lead worms, on two trucks (Shay) that no matter what you do lurch at low speeds with worm lock. All our rod engines have been upgraded with new gearboxes using double lead and ball bearings, and double heading can be...interesting on downgrades.

I suppose flat and level track would be less of an issue, but on a downgrade?
I'd like to see one of the non-existent 4-motor GG1's someday and run it. Garberson has a good downgrade from upper level to lower.
Dave....gone by invitation


Return to “O-Gauge, 2-Rail, Model Railroading”

Who is online

Users browsing this forum: No registered users and 49 guests